Creating a rule configuration

There are different approaches to creating a rule configuration. The basic procedure for creating a rule configuration is always the same. It consists of three steps, which are referred to below as Start, Option and Configuration.

Step 1: Start

1. Go to the area for managing rule configurations:

   

2. In Language select the language for your rule configuration. You can choose between German, English, French and Spanish.
3. In Sublanguage select the sublanguage for your rule configuration.

4. Click Create: 

   
   

   1. The following window will open up:

      

5. Enter a name for your configuration.
6. Go on to Step 2: Option.

Step 2: Option

Start with the preselected rule configuration

1. Select one of the following ready-to-use rule configurations by clicking on the appropriate button:

   

2. Go on to Step 3: Configuration .

Start without the preselected rule configuration

1. Select that no rules are preconfigured by clicking the appropriate button:

   

2. Go on to Step 3: Configuration .

Step 3: Configuration

Requirements

• You are here:
  
• You have selected one of two preconfigured rule sets or No preselection.

Create a rule configuration using the Rule wizard

1. Click Wizard:

   

   1. The Rule wizard will open up:

      

2. Optional: Enter a deprecated example and a positive example in the Example area.
3. Optional: Select a counter value. If the rule can be configured using a counter value, the Select button in the Counter is enabled.

4. Decide whether the rule should be enabled in your rule configuration.

   1. If you want the rule to be enabled, click Yes.

      1. The Rule wizard will go to the next rule.
      2. The counter increases by a value of 1.
      3. The rule has been successfully enabled as part of your rule configuration.

   2. Click No if the rule is not be enabled.

      1. The Rule wizard will go to the next rule.
      2. The counter increases by a value of 1.
      3. The rule has not been enabled as part of your rule configuration.

   3. If you are not yet sure whether the rule should be enabled, click Ask later.

      1. The Rule wizard will go to the next rule.
      2. The counter will remain the same.
      3. The rule was temporarily not enabled as part of your rule configuration.

How to create a rule configuration without the wizard

1. Click Create:

   

   
   

   1. The panel will close.
   2. If you have selected one of the two preconfigured rule configurations, the checkboxes of the relevant rules are enabled.
   3. If you selected No preselection, no checkboxes are selected.

2. Select all desired rules in the different rule categories by enabling the appropriate checkbox:

   

   Or: Enable all rules by enabling the checkbox to the left of Rule in each rule category: