There are different approaches to creating a rule configuration. The basic procedure for creating a rule configuration is always the same. It consists of three steps, which are referred to below as Start, Option and Configuration.
Step 1: Start
...
Go to the area for managing rule configurations:
...
Click Create: 
...
The following window will open up:
...
Step 2: Option
Start with the preselected rule configuration
...
Select one of the following ready-to-use rule configurations by clicking on the appropriate button:
...
Start without the preselected rule configuration
...
Select that no rules are preconfigured by clicking the appropriate button:
...
Requirements
- You are here:
- You have selected one of two preconfigured rule sets or No preselection.
...
Create a rule configuration using the Rule wizard
| Info | ||
|---|---|---|
| ||
A description of the Rule wizard interface is available here: Style Guide – Rules |
...
Click Wizard:
The Rule wizard will open up:
...
...
Decide whether the rule should be enabled in your rule configuration.
If you want the rule to be enabled, click Yes.
- The Rule wizard will go to the next rule.
- The counter increases by a value of 1.
- The rule has been successfully enabled as part of your rule configuration.
Click No if the rule is not be enabled.
- The Rule wizard will go to the next rule.
- The counter increases by a value of 1.
- The rule has not been enabled as part of your rule configuration.
If you are not yet sure whether the rule should be enabled, click Ask later.
- The Rule wizard will go to the next rule.
- The counter will remain the same.
- The rule was temporarily not enabled as part of your rule configuration.
How to create a rule configuration without the wizard
Click Create:
...
Select all desired rules in the different rule categories by enabling the appropriate checkbox:
Or: Enable all rules by enabling the checkbox to the left of Rule in each rule category:
...
| Info |
|---|
All changes to a rule configuration are saved automatically. |